Wireless Beeper Definitions - Motorola Symbol MT2070 User Manual

Wireless Beeper Definitions

When the device scans the pairing bar code it issues various beep sequences indicating successful or
unsuccessful operations. See
Wireless Beeper Definitions
Table 4-2
Beeper Sequence
Short low-high beeps
Short high-low beeps
Long low-long high beeps
Long low-long high-long low-long high beeps
Four long low beeps
Five high beeps
Table 4-2 for beep sequences that occur during pairing operations.
Device has paired with the cradle.
Device has unpaired with the cradle.
Note: When connected to a remote device using SPP or HID, if a
disconnect beep sequence sounds immediately after scanning a bar
code, check the host device to determine if it received the transmitted
data. The device may have transmitted the last bar code scanned after
losing the connection.
Unsuccessful pairing attempt. See
4-14.
Remote device rejected connection attempt, possibly due to an attempt
to pair with a cradle that is already paired with the maximum number of
devices.
1. A transmission error was detected in a scanned symbol. The data is
ignored. This occurs if a unit is not properly configured. Check option
setting.
2. When communicating with a cradle, the cradle acknowledges
receipt of data. If the acknowledgment is not received, this transmission
error beep sequence sounds. Data may still have been received by the
host. Check the host system for receipt of transmitted data. If data was
not received by the host, re-scan the bar code.
Emitted every 5 seconds while a reconnect attempt is in progress. See
Auto-reconnect Feature on page
Radio Communications
Indication
Auto-reconnect Feature on page
4-14.
4 - 3