Hand-Held Trigger Mode; Decode Session Timeout - Motorola Symbol MT2070 User Manual

5 - 10 Symbol MT2070/MT2090 User Guide

Hand-Held Trigger Mode

Parameter # 8Ah
Select one of the following trigger modes for the device:
•
Standard (Level) - A trigger pull activates decode processing. Decode processing continues until the bar
code decodes, you release the trigger, or the Decode Session Timeout occurs.
•
Presentation (Blink) - The device activates decode processing when it detects a bar code in its field of view.
After a period of non-use, the device enters a low power mode, in which the LEDs turn off or blink at a low
duty cycle until the device senses motion.
NOTE Laser scanning is not applicable in hand-held presentation mode.
*
Standard (Level)

Decode Session Timeout

Parameter # 88h
This parameter sets the maximum time decode processing continues during a scan attempt. It is programmable in
0.1 second increments from 0.5 to 9.9 seconds. The default timeout is 9.9 seconds.
To set a Decode Session Timeout, scan the bar code below. Next, scan two numeric bar codes from
Numeric Bar Codes
example, to set a Decode Session Timeout of 0.5 seconds, scan the bar code below, then scan the 0 and 5 bar
codes. To correct an error or change the selection, scan
Decode Session Timeout
(00h)
that correspond to the desired on time. Enter a leading zero for single digit numbers. For
Presentation (Blink)
(07h)
Cancel on page D-3.
Appendix D,