Verifying The Ethernet Statistics - Cisco MGCP IP Phone Administrator's Manual

Chapter 5 Monitoring and Maintaining the Cisco MGCP IP Phone
•
•
•
•
•
•
•
•
•
•
To exit the Network Statistics panel, press the Exit soft key.
Step 6
Note To reset the values displayed on Network Statistics panel, power off and power on the phone.

Verifying the Ethernet Statistics

Use the show ethernet command to verify the ethernet statistics. The following is sample output:
MGCP Phone> show ethernet
Ethernet Mib:
---------------------------------------------------
ResErr 00000154, RcvCnt 00137436, RcvErr 00000000, DrpCnt 00001421
BrdCst 00122041, TooLng 00000363, TxCnt
TxQue
Overflow Counters...
UDP 00000000, ICMP
CDP 00000000, Unknown 00000000, Arp
Use the show ip command to verify the IP statistics. The following is sample output:
MGCP Phone> show ip
IP Statistics:
---------------------------------------------------
Phone Initialized—TCP connection has not gone down since the phone was powered on.
–
– Phone Closed TCP—TCP connection was closed by the phone.
– TCP Timeout—TCP connection was closed because of a retry timeout.
– Error Code—Error messages indicating unusual reasons the TCP connection was closed.
Elapsed Time—Length of time (in days, hours, minutes, and seconds) since the last power cycle.
Port 0 Full, 100—Indicates that the network is in a linked state and has autonegotiated a full-duplex
100-Mbps connection.
Port 0 Half, 100—Indicates that the network is in a linked state and has autonegotiated a half-duplex
100-Mbps connection.
Port 0 Full, 10—Indicates that the network is in a linked state and has autonegotiated a full-duplex
10-Mbps connection.
Port 0 Half, 10—Indicates that the network is in a linked state and has autonegotiated a half-duplex
10-Mbps connection.
Port 1 Full, 100—Indicates that the network is in a linked state and has autonegotiated a full-duplex
100-Mbps connection.
Port 1 Half, 100—Indicates that the network is in a linked state and has autonegotiated a half-duplex
100-Mbps connection.
Port 1 Full, 10—Indicates that the network is in a linked state and has autonegotiated a full-duplex
10-Mbps connection.
Port 1 Half, 10—Indicates that the network is in a linked state and has autonegotiated a half-duplex
10-Mbps connection.
ethernet—Indicates the ???
00000000, TxQMax 00000000, TxXCol 00000000, TxFram 00012322
00000000, NonIP 00000000, TCP 00000000
00012322, TxQCnt 00000000
00000000
Cisco MGCP IP Phone Administrator Guide, Release 5.0 and Release 5.1
5-7