Table of Contents
Advertisement
Using Configuration Files
# sntp_server - specifies the address of the SNTP server
sntp_mode : Unicast
sntp_server : "1.2.3.4"
# The following parameters setup time zone and
# daylight savings settings.
# Supported time zones are :
#
EST, AST, NST, BST, AT, WAT, GMT, HST, YST
time_zone
dst_offset
dst_start_month
dst_start_day
dst_start_day_of_week
dst_start_week_of_month : 1
dst_start_time
dst_stop_month
dst_stop_day
dst_stop_day_of_week
dst_stop_week_of_month
dst_stop_time
dst_auto_adjust
# Date and Time format displays
# time_format_24hr (1 - yes, 0 - 12 hours format)
# date_format (M/D/Y, D/M/Y, Y/M/D, Y/D/M)
time_format_24hr : 1
date_format : M/D/Y
# Language - specifies which language to use for
# internal strings [english (default), swedish]
language: "english"
# MGCP Call Agent Information
# mgcp_gw_controller - address of call agent
# mgcp_input_port - port the phone listens on
# mgcp_output_port - port the call agent listens on
# mgcp_keepalive - specifies if the RSIP keepalive should
#
be used to keep NAT bindings open to the Call Agent.
#
values are [0 - off (default), 1 - on]
# mgcp_keepalive_timer - specifies the time interval to
#
use for the mgcp keepalive timer if turned on.
#
values are in seconds [10 to 600, 30 is default].
mgcp_gw_controller : 1.2.3.4
mgcp_input_port : 2427
mgcp_output_port : 2727
mgcp_keepalive: 1
mgcp_keepalive_timer: 30
# xml_card_dir - specifies the directory to use for the
#
retrieving the xml cards file. The base
#
for the directory is the base TFTP Server directory.
#
xml_card_dir is limited to 64 characters.
# xml_card_file - specifies the file name of the XML Cards
#
file. xml_card_file is limited to 20 characters.
xml_card_dir : ""
xml_card_file : "CARD.XML"
# tos_media - specifies the value to be used for the tos bits.
#
valid range is 0-7.
tos_media: 7
#use_mac_name - specifies whether to use the IP address
#
#
Cisco MGCP IP Phone Administrator Guide, Release 5.0 and Release 5.1
3-10
: EST
: 1
: "April"
: 0
: "Sun"
: 2
: "Oct"
: 0
: "Sun"
: 8
: 2
: 1
or MAC Address in the endpoint name. The default is
to use the IP address. Valid values are :
Chapter 3
Configuring the Cisco MGCP IP Phone
Advertisement
Table of Contents
