Spark Plug Connector - Removal And Installation - MTU Gas engine8 V 4000 L62 Operating Instructions Manual

5.3.3 Spark plug connector – Removal and installation
Preconditions
☑ Engine is stopped and starting disabled.
☑ Open protective packing of new spark plug connector only immediately prior to installation.
Special tools, Material, Spare parts
Designation / Use
Torque wrench, 10-60 Nm
Spark plug wrench
Spark plug connector with ignition line
Locking plate
Sealing ring
WARNING
Component is hot.
Risk of burning!
• Wear protective gloves.
WARNING
Compressed air
Risk of injury!
• Do not direct compressed-air jet at persons.
• Wear protective goggles / safety mask and ear protectors.
Removing spark plug connector
1. Remove protective cap (3) from ignition coil
(1).
2. Remove screw (2), take off spring washer.
3. Remove screws (5) and tab washer (7)
from cylinder head cover.
4. Remove spark plug connector (6) with igni‐
tion cable (4) from spark plug.
5. Remove sealing ring from Teflon sleeve of
ignition line.
54 | Task Description | MS150032/02E 2012-07
Part No.
F30452769
F30452574
(→ Spare Parts Catalog)
(→ Spare Parts Catalog)
(→ Spare Parts Catalog)
Qty.
1
1