MTU Gas engine8 V 4000 L62 Operating Instructions Manual page 51

3. Remove locknut (1).
4. Remove filter cover (3) with washer (2).
5. Carefully lift out fine filter (6).
6. Carefully lift out coalescence filter (5).
7. Clean sealing faces and inside of housing.
8. Check condition of gaskets on new fine fil‐
ter and new coalescence filter.
Note: The fine filter (6) must be installed in correct
position in housing.
9. Place fine filter (6) in housing, ensuring it is
straight.
Note: The coalescence filter (5) must be installed
in correct position in housing.
10. Place coalescence filter (5) in housing, en‐
suring it is straight.
11. Fit filter cover (3), ensuring it is positioned
correctly.
12. Screw on washer (2) with new locknut (1) and tighten to specified tightening torque with torque wrench.
Name
Locknut
13. Fit housing cover (1).
14. Fit clamping closure (2) correctly and tight‐
en on both sides evenly to 5 Nm.
Size Type
Tightening torque
Lubricant
MS150032/02E 2012-07 | Task Description | 51
Value/Standard
15 Nm