Table of Contents
Advertisement
Initializing the Voice Mail for Your Phone System
Installing the Phone System
Initializing the Vo ice Mail for Your Phone System
Installing th e Phone System
Initializing the Voice Mail for Your Phone System
Installing the Phone System
16
NVM-2e/i-Series Quick Setup Guide
At default, the Voice Mail database should already have the i-Series as the installed phone
system. However, it is recommended that you verify that the i-Series is the installed phone system.
To program the Voice Mail as explained below, your NVM-2e requires software version 2.00 or
higher.
To verify that an i-Series phone system is installed in the Voice Mail:
This option is also available on the Database Management Menu. For
more information, see Database Management Menu Tree in Chapter
6.
1.
Turn on the laptop or other computer, and access the communications software.
When the computer is communicating with the Voice Mail, you will see the MAIN MENU ->
prompt.
At the MAIN MENU -> prompt, press IN and then Enter to select Install System.
2.
The Install System Menu will be displayed. Each phone system on this menu corresponds to
a number in the column at the left.
******* INSTALL SYSTEM Menu *******
Press command below,
then press Enter:
1
2
3
4
90
91
92
E
3.
The default entry should already be 2 (the number that corresponds to the 28i/124i phone
system). If it isn't, enter 2 and press Enter.
4.
Follow the instructions on your Voice Mail screen.
For information about integrating the i-Series with the Voice Mail, see Chapter 3: Phone
System Programming starting on page 11.
To Install the Voice Mail
System for:
PORTRAIT 308/824
28i/124i
ONYX VS/VSI/DS100/DS01
DS2000
To Install Voice Mail Ports only
To Install Voice Compression Rate only
To View Current Settings
To Exit to MAIN Menu
Chapter 4: Voice Mail Programming
Advertisement
Table of Contents
