Table of Contents
Advertisement
Connecting the Voice Mail to a Phone System
Connecting to the i-Series Phone System
Connecting the Vo ice Mail to a Phone System
Connecting to the i-Series Phone System
Connecting the Voice Mail to the i-Series Phone System
Availability:
To Analog Station Port
a Port on a 2-OPX Module
Figure 6: Connecting an i-Series Phone System to the NVM-2e
10
NVM-2e/i-Series Quick Setup Guide
All versions of the NVM-2e integrate with the i-Series.
To connect the NVM-2e to the i-Series Phone System:
1.
Plug one end of a modular line cord into Port 1 on the NVM-2e.
Plug the other end into an analog station port or a port on a 2-OPX Module, as
shown in Figure 6.
2.
Repeat step 1 for Port 2.
3.
Repeat step 1 for Ports 3 and 4 if your Voice Mail contains 4 ports.
Extensions will receive notification of new messages (blinking Message Waiting Lights
and interrupted dial tone for single line phones) only if Voice Mail Port 2 is connected
to the phone system.
.
Port 2
Port 3
Port 1
To Analog Station Port
or
a Port on a 2-OPX Module
IMPORTANT NOTE
Port 4
IOIOI
or
Chapter 2: Installing the Voice Mail
24 VAC
0.7A 50-60Hz
NVM2exVB-C6
AC Power Cord
AC Adapter
Advertisement
Table of Contents
