Table of Contents
Advertisement
Mixer/Tuning: Tuning
Parameters
See "Mixer/Tuning: Tuning" on page 92.
Mixer/Tuning: Sub Scale
This page lets you program an alternative scale for the selected
tracks (via the "Track Assign" parameter).
tracks (if any) use the basic scale set in Global mode (see
"Main Scale" on page 198).
Note: Quarter Tone selection and activation of the Sub-Scale on
each track of a Song, can be received by MIDI (i.e., by an external
sequencer or controller). Conversely, selection of Quarter Tone set-
tings, or activation of the Sub-Scale on each track of the Song, can
be sent by the Pa800 to an external MIDI recorder as System Exclu-
sive data.
Parameters
See "Mixer/Tuning: Sub Scale" on page 92.
Track Assign
Check the parameter corresponding to each track where the
Sub-Scale must be used.
Play/Mute icon
Track's play/mute status.
Play status. The track can be heard.
Mute status. The track cannot be heard.
Effects: FX Select
This page allows you to select effects to be assigned to the four
Internal FX processors (A-D).
The remaining
Note: When you stop the Song, or select a different Song, the
default effects are selected again. You can, however, stop the Song,
change the effects, then start the Song again. Save the Song to per-
manently change the effects.
FX A...D
Effects assigned to the corresponding effect processors. Usually,
A and C are reverbs, while B and D are modulating effects (cho-
rus, flanger, delay...). For a list of the available effects, see the
"Advanced Edit" addendum in the Accessory CD.
FX Amount
Volume of the effect, that is added to the dry (uneffected) signal.
B to A, D to C
Amount of the B effect going back to the input of the A effect, or
of the D effect going back to the input of the C effect.
Mod.Track (Modulating Track)
Source track for modulating MIDI messages. You can modulate
an effect parameter with a MIDI message generated by a physical
controller.
Sequencer operating mode
Mixer/Tuning: Tuning
185
Advertisement
Table of Contents
