Specifications - Infopia finetest IGM-0005A Operation Manual

Troubleshooting
Please refer to the table below to identify problems that persist with no messages appearing.
PROBLEM CAUSED BY
The meter does not Batteries are dead or there is a
power on problem with the meter.
Test does not start Poor amount of sample
after applying blood
sample
Problem with the test strip
The result is doubtful There may be a problem with the
test strip
The codes of the meter and of the
test strip vial do not match
[ 27 ]
finetest TM
WHAT TO DO
Change the batteries and if the problem persists, contact
your local representative.
Apply a sufficient amount of the blood sample to a new test
strip and re-test.
Re-test with a new strip.
Re-test with a new strip.
Re-code the meter and re-test.

Specifications

Specifications
Model IGM-0005A
Test Range 0.6 ~ 33.3 mmol/L (10 ~ 600 mg/dL)
Reading Time 9 sec
Memory Capacity 200 test results
Operating Temperature 50 ~ 86˚F(10 ~ 40˚C )
Operating Humidity 10 ~ 90%
Sample Type Capillary Whole Blood
Calibration Plasma-Equivalent
Hematocrit 30 ~ 55%
Sample Volume Minimum 1.5 µl
Display Type LCD
Size (D X W X H) 81 56 23 (mm)
X X
Weight Less than 40g ± 1(including batteries)
Power Source 3V Li Battery (CR2032) 1
X
Battery Life running 5000 tests
Glucose Unit Either mmol/L or mg/dL
INFOPIA [ 28 ]