Wireless Broadband Connection (Wireless Wan); Advanced Settings; Lan Settings; Wan Settings - Teltonika RUT600 User Manual

3. Wireless Broadband Connection (Wireless WAN)

Internet or you want to amplify wireless signals, please select "Wireless WAN" in "WAN
Medium" page after you enter the Router's setup page.
parameters provided by your Wi-Fi ISP. It is also possible to click "Auto Scan" to find ISP
automatically. Select and save the settings, and you will enter the Router's Web interface
again after rebooting the Router.
Note: When you open the wireless WAN feature or when you have another wireless router
and you want to amplify wireless signals, please pay attention to the IP address the
previous router distributed. If the IP address belongs to the range: 192.168.0.x, you need to
change the LAN IP address to different range such as 192.168.2.1. Only this way, you can
amplify the wireless signals and access the Internet. Please refer to chapter 6.1 for changing
method.
You do not need to change LAN IP range if the router was connected to your wireless
broadband ISP.

5.3 Advanced Settings

1. LAN Settings

ports.
MAC Address: The Router's physical MAC address as seen on your local network
is unchangeable.
IP Address: The Router's LAN IP addresses (not your PC's IP address).
192.168.0.1 is the default value.
Subnet Mask:
network size. 255.255.255.0 is the default value.
Note: Once you modify the IP address, you need to remember it for future logins.

2. WAN Settings

you have selected the ISP connection type in "Setup Wizard".
Virtual Dial-up (PPPoE)
WAN Connection Mode: Shows your current connection mode.
Account: Enter as provided by your ISP.
Password: Enter as provided by your ISP.
MTU: Maximum Transmission Unit. Is the size of the largest datagram that can
be sent over a network. The default value is 1492. Do NOT modify it unless
necessary. If some specific website or web-application software cannot be opened
or enabled, you can have a try changing the MTU value to 1450, 1400, etc.
Service Name: It is defined as a set of characteristics that are applied to a PPPoE
connection. Enter it if provided. Do NOT modify it unless necessary.
AC Name: Enter it if provided. Do NOT modify it unless necessary.
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
If you are provided with the wireless broadband by your ISP to access the
Please enter the wireless SSID, Mac address, channel, security mode
LAN Settings are used to configure the basic TCP/IP parameters of LAN
Router's
This section is used to modify and configure WAN settings in details after
subnet mask is used for setting the
14