Traffic Control; Traffic Statistics - Teltonika RUT600 User Manual

5.7 Traffic Control

1. Traffic Control
Traffic control is used to limit communication speed over the LAN. Up to 20 entries can
be supported to control a maximum of 254 PCs'.
Enable Traffic Control: Is used to enable or disable the internal IP bandwidth
control. The default is "Disabled".
Interface: Is used to limit the uploading and downloading bandwidth on WAN
port.
Service: Is used to select the controlled service type, such as HTTP service.
IP Starting Address: The first IP address for traffic control.
IP Ending Address: The last IP address for traffic control.
Uploading/Downloading: Specify the traffic direction for the selected IP
addresses: upload or download.
Bandwidth: Specify the upload/download Min./Max. traffic speed (KB/s). It
cannot exceed the WAN speed.
Apply: Enable the edited rule. If not, the rule will be disabled.
Add To List: After editing the rule, click the "Add To List" button to add the
current rule to rule list.
Apply: Click "Apply" to activate the current rule.
Cancel: Click "Cancel" to roll back to the last saved settings..

2. Traffic Statistics

Traffic statistics is used to show the LAN PC's traffic information.
Enable: check to enable traffic statistics. By default traffic statistics is disabled,
which can improve the Router's data handling. If it is enabled, the data traffic
information page will be updated every 5 seconds.
IP address: The IP address to be shown.
Upload rate: the speed of upstream data per second (Kbyte/S).
Download rate: the speed of downstream data per second (Kbyte/S).
Sent packets: sent from the PC packets.
Sent bytes: Sent from the PC information amount in Mbytes.
Received packets: The number of packets received from the Router.
Received bytes: The information amount in Mbytes received from the Router.
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
25