Scan Voting Selection
When Scan Voting is enabled, the scanner requires three (3) identical,
consecutive scans before the bar code data will be accepted and transmitted
to the terminal. When this selection is disabled, the bar code data will be
transmitted following one (1) valid scan.
Enable
Code I.D. Transmit Selection
This selection allows you to enable or disable transmission of a Code I.D. before
the decoded bar code symbology. (See the Symbology Chart on page 2-6
for the single character code that identifies each symbology.)
Enable
AIM I.D. Transmit Selection
This selection allows you to enable or disable transmission of an AIM I.D. before
the decoded bar code symbology.
Identifiers for more information on the AIM symbology ID characters.) Default
= Disable.
Enable
Function Code Transmit Selection
When this selection is enabled, and function codes are contained within the
scanned data, the scanner transmits the key code (which corresponds to the
decoded ASCII function code) to the terminal. ASCII function codes are
represented by the HEX values 00-1F. (Charts of these function codes are
shown in Section 6, Supported Interface Keys.)
Enable
SCANTEAM 3400PDF User's Guide
Disable
Disable
(See AIM Guidelines on Symbology
Disable
Disable
2–11