Connecting The Scanner - Welch Allyn Scansteam 3400PDF User Manual

Connecting the Scanner

Install the scanner by following the steps shown below:
Turn off the power to the host system.
Connect the interface cable to the scanner and to the terminal/computer.
3
Disconnect
1
(Cable, Keyboard, and Terminal will vary.)
Turn on the power to the host system.
Program your scanner to work with your terminal or computer by scanning
the Terminal Set-Up Codes. Either scan the Plug and Play codes (Page
1-7) or use the Supported Terminal list (Pages 1-9) to determine your
terminal's Terminal ID.
With Plug and Play programming, you connect the scanner and scan only one
bar code and required prefixes and suffixes to program the scanner to work
with a designated interface.
To determine if your scanner is set up correctly, scan one of the sample bar
codes on the back cover of this guide.
SCANTEAM 3400PDF User's Guide
2
Keyboard Wedge Interface Example
1–3