Table of Contents
Advertisement
2.3
Terminal Selection Programming Instructions
Use this section to program the 3700 Wedge to work with any supported terminal or
computer.
To program the 3700 Wedge:
–
Locate the two digit terminal I.D. number for your terminal or computer.
—
Scan the Program Terminal Interface bar code.
˜
Scan the bar code representing the first digit of the terminal I.D. number.
(e.g., for an IBM AT, scan the number 0.)
™
Scan the bar code representing the second digit of the terminal I.D.
number. (e.g., for an IBM AT, scan the number 3.)
Terminal/Model Terminal ID
IBM PC/XT
Terminal/Model Terminal ID
IBM PS/2 25, 30
Terminal/Models Terminal ID
IBM AT, PS/2
30-286, 50,
55SX, 60, 70,
70-061,
70-121, 80
Your terminal interface is set up.
If you wish to program a carriage return (CR) suffix or turn off the carriage return (or any other
suffix), see the Quick Suffix Selections" on the next page.
SCANTEAM 3700 Wedge Technical Manual
01
Program Terminal Interface
0
02
Program Terminal Interface
0
03
Program Terminal Interface
0
1
2
3
2–3
Advertisement
Table of Contents
