Removing The Water Reservoir - KitchenAid KSBP25FKSS00 Technical Education

REMOVING THE WATER RESERVOIR

Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so can result in death or
electrical shock.
NOTE: Sharp edges may be present.
1. Unplug the refrigerator or disconnect the
power.
NOTE: The water reservoir location is shown
below.
Water Reservoir On Rear Liner
NOTE: If the water reservoir tubing located
inside the refrigerator compartment becomes
damaged, you can cut and splice a new reser-
voir in its place using two 5/16" unions
(#4388201). If the tubing located under the
refrigerator is defective, it will be necessary to
remove the unit from its mounting location to
repair it. If that is the case, use the following
procedure.
2. Open the refrigerator and freezer doors
and remove the two screws from the base
grille and remove the grille from the front of
the unit.
Screw
3. Place a container near the base grille to
catch the water in the next step.
4. Disconnect the water dispenser fill tube
from the union, slide the nut off the end of
the tube, and allow the water to drain into
the container.
Water Dispenser Tubing & Union Nut
Continued on the next page.
4-7
Screw
Base Grille