KitchenAid KSBP25FKSS00 Technical Education page 30

4. To remove the auger motor or crush/
cube solenoid:
a) Remove the light shield and the bulb
from the socket.
b) Remove the four hex-head screws from
the auger assembly and pull the as-
sembly forward.
Screws
Light Shield & Bulb
c) Remove the green ground wire screw,
disconnect the electrical harness con-
nector, and remove the auger assem-
bly.
Harness Connector
Ground Wire
Auger Assembly
Screws
d) To remove the auger, unscrew the drive
coupler (left-hand threads) and remove
it from the motor shaft.
e) Remove the three auger motor hex-
head screws from the housing.
Drive Coupler
Solenoid Screws
f) Disconnect the wires from the auger
motor terminals.
g) To remove the crush/cube solenoid,
remove the two hex-head mounting
screws from the housing (see above).
h) Disconnect the wires from the solenoid
terminals.
Auger Motor Wires
Solenoid Wires
Electrical Shock Hazard
Connect green ground wire to ground
screw.
Failure to do so can result in death or
electrical shock.
4-10
Remove
Auger Motor
Screw (1 of 3)