KitchenAid KSBP25FKSS00 Technical Education page 34

g) Pull the bottom of the evaporator to-
ward the front of the unit and remove
the two hangers from the defrost heater.
Defrost Heater Hangers
h) Slide the defrost heater off the evapo-
rator.
Defrost Heater
10. To remove the evaporator:
a) Remove the defrost heater from the
evaporator (see page 4-13).
b) Access the sealed system and dis-
charge the refrigerant into an approved
recovery system.
c) Remove and replace the evaporator.
REASSEMBLY NOTES:
1. The evaporator fan motor shroud has a
foam insert on each side. Note the position
of these inserts in the photo and reinstall
them correctly, as shown.
Evaporator Fan Motor Shroud
2. Be sure to reinstall the left styrofoam block
and the right foam block at the locations
shown below.
Left Styrofoam Block
4-14
Foam Inserts
Right Foam Block