Figure 1-5. Pmcspan16E-010 Installation On A Pmcspan16E-002 - Emerson MVME51005E Installation And Use Manual

1 Hardware Preparation and Installation
Warning
Caution
Note
This procedure assumes that you have read the user's manual that was furnished with
the PMCspan, and that you have installed the selected PMC modules on your
PMCspan according to the instructions provided in the PMCspan and PMC manuals.
MVME5100 and
PMCspan16E-002
Assembly

Figure 1-5. PMCspan16E-010 Installation on a PMCspan16E-002

1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an electrical
ground. Note that the system chassis may not be grounded if it is unplugged. The ESD
strap must be secured to your wrist and to ground throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power off and remove the
AC cord or DC power lines from the system. Remove chassis or system cover(s) as
necessary for access to the VME module.
3. If the Primary PMC Carrier Module and MVME5100 assembly is already installed in the
VME chassis, carefully remove it as shown in
P1 and P2 facing you.
10
MVME51005E Single Board Computer Installation and Use (6806800A38B)
Dangerous voltages, capable of causing death, are present in this equipment.
Use extreme caution when handling, testing, and adjusting.
Inserting or removing modules with power applied may result in damage to
module components. Avoid touching areas of integrated circuitry, static
discharge can damage these circuits.
PMCspan16E-010
P3
J3
2065 9708
Figure 1-2 and place it with connectors