Hardware Preparation And Installation; Overview - Emerson MVME7100 Installation And Use Manual

Hardware Preparation and Installation

2.1

Overview

This chapter provides startup and safety instructions related to this product, hardware
preparation instruction that includes default switch settings. System considerations and
installation instructions for the baseboard, PMC, and transition module are also described in
this chapter.
A fully implemented MVME7100 consists of the baseboard plus:
Two single-wide or one double-wide PCI Mezzanine Card (PMC) slot for added versatility.

One transition module for support of the mapped I/O from the MVME7100 baseboard to

the P2 connector.
Up to two optional XMCspan cards.

The following table lists the things you will need to do before you can use this board and tells
you where to find the information you need to perform each step. Be sure to read this entire
chapter, including all Caution and Warning notes, before you begin.
Table 2-1 Startup Overview
Task
Unpack the hardware.
Configure the hardware by setting jumpers
on the board and RTM.
Install the MVME7216E transition module in
the chassis.
Install PMC module (if required).
Install XMCspan module (if required).
Install the MVME7100 in the chassis.
Attach cabling and apply power.
Install PIM on transition module (if required).
Ensure that the firmware initializes the
MVME7100
Initialize the board
Examine and/or change environmental
parameters.
MVME7100 Single Board Computer Installation and Use (6806800E08C)
Page
Unpacking and Inspecting the Board on page 26
Configuring the Board on page 33
Switch, S1 on page 84
Transition Module on page 40
Installing Accessories on page 39
XMCspan Installation and Use (6806800H03)
Installing and Removing the Board on page 44
Completing the Installation on page 45
PMC Input/Output Module on page 89
Chapter 6, MOTLoad Firmware
Chapter 6, MOTLoad Firmware
MVME7100 Single Board Computer Programmer's Reference
Chapter 2
and SEEPROM Address
25