Table of Contents
Advertisement
Hardware Preparation and Installation
1.1
Overview
The MVME3100 is a single-slot, single-board computer based on the MPC8540 PowerQUICC
III™ integrated processor. The MVME3100 provides serial ATA (sATA), USB 2.0, 2eSST VMEbus
interfaces, dual 64-bit/100 MHz PMC sites, up to 128MB of Flash, dual 10/100/1000 Ethernet,
one 10/100 Ethernet, and five serial ports. This board supports front and rear I/O and a single
SODIMM module for DDR memory. Access to rear I/O is available with the MVME721 rear
transition module (RTM).
Front-panel connectors on the MVME3100 board include: one RJ-45 connector for the Gigabit
Ethernet, one RJ-45 connector for the asynchronous serial port, one USB port with one type A
connector, one sATA port with one external sATA connector, and a combined reset and abort
switch.
Rear-panel connectors on the MVME721 board include: one RJ-45 connector for each of the
10/100 and 10/100/1000 BaseT Ethernets and four RJ-45 connectors for the asynchronous
serial ports. The RTM also provides two planar connectors for one PIM with rear I/O.
1.2
Getting Started
This section provides an overview of the steps necessary to install and power up the
MVME3100 and a brief section on unpacking and ESD precautions.
1.2.1
Overview of Startup Procedures
The following table lists the things you will need to do before you can use this board and tells
where to find the information you need to perform each step. Be sure to read this entire
chapter, including all Caution and Warning notes, before you begin.
Table 1-1 Startup Overview
What you need to do...
Unpack the hardware.
Identify various components on the board.
Install the MVME3100 board in a chassis.
MVME3100 Single Board Computer Installation and Use (6806800M28C)
Refer to...
Unpacking Guidelines on page 22
MVME3100 Layout on page 23
on page 30
Chapter 1
21
Advertisement
Table of Contents
