Pmc Modules; Figure 1-2. Mvme5100 Installation And Removal From A Vmebus Chassis - Emerson MVME51005E Installation And Use Manual

PMC Modules

PMC modules mount on top of the MVME5100. Perform the following steps to install a PMC
module on your MVME5100.
Warning
Caution
Note
This procedure assumes that you have read the user's manual that came with your
PMCs.
1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an electrical
ground. Note that the system chassis may not be grounded if it is unplugged. The ESD
strap must be secured to your wrist and to ground throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power off and remove the
AC cord or DC power lines from the system. Remove chassis or system cover(s) as
necessary for access to the VME modules.
3. If the MVME5100 has already been installed in a VMEbus card slot, carefully remove
it as shown in
4. Remove the filler plate(s) from the front panel of the MVME5100.
5. Align the PMC module's mating connectors to the MVME5100's mating connectors and
press firmly into place.
6. Insert the appropriate number of Phillips screws (typically 4) from the bottom of the
MVME5100 into the standoffs on the PMC module and tighten the screws (refer to
Figure

Figure 1-2. MVME5100 Installation and Removal From a VMEbus Chassis

Dangerous voltages, capable of causing death, are present in this equipment.
Use extreme caution when handling, testing and adjusting.
Inserting or removing modules with power applied may result in damage to
module components. Avoid touching areas of integrated circuitry, static
discharge can damage these circuits.
Figure 1-2 and place it with connectors P1 and P2 facing you.
1-3).
MVME51005E Single Board Computer Installation and Use (6806800A38B)
1 Hardware Preparation and Installation
7