Primary Pmcspan; Figure 1-3. Typical Pmc Module Placement On An Mvme5100 - Emerson MVME51005E Installation And Use Manual

1 Hardware Preparation and Installation

Figure 1-3. Typical PMC Module Placement on an MVME5100

Primary PMCspan

To install a PMCspan16E-002 PCI expansion module on your MVME5100, perform the
following steps while referring to the figure on the next page:
Warning
Caution
Note
This procedure assumes that you have read the user's manual that was furnished with
your PMCspan and that you have installed the selected PMC modules on to your
PMCspan according to the instructions provided in the PMCspan and PMC manuals.
1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an electrical
ground. Note that the system chassis may not be grounded if it is unplugged. The ESD
strap must be secured to your wrist and to ground throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power off and remove the
AC cord or DC power lines from the system. Remove chassis or system cover(s) as
necessary for access to the VME modules.
3. If the MVME5100 has already been installed in a VMEbus card slot, carefully remove
it as shown in
4. Attach the four standoffs to the MVME5100. For each standoff:
8
MVME51005E Single Board Computer Installation and Use (6806800A38B)
Dangerous voltages, capable of causing death, are present in this equipment.
Use extreme caution when handling, testing, and adjusting.
Inserting or removing modules with power applied may result in damage to
module components. Avoid touching areas of integrated circuitry, static
discharge can damage these circuits.
Figure 1-2 and place it with connectors P1 and P2 facing you.