Mvme5100 - Emerson MVME51005E Installation And Use Manual

4. Remove four screws (Phillips type) from the standoffs in each corner of the primary PCI
expansion module.
5. Attach the four standoffs from the PMCspan-010 mounting kit to the PMCspan-002 by
screwing the threaded male portion of the standoffs in the locations where the screws
were removed in the previous step.
6. Place the PMCspan-010 on top of the PMCspan-002. Align the mounting holes in each
corner to the standoffs and align PMCspan-010 connector P3 with PMCspan-002
connector J3.
7. Gently press the two PMCspan modules together and verify that P3 is fully seated in
J3.
8. Insert the four screws (Phillips type) through the holes at the corners of PMCspan-010
and into the standoffs on the primary PMCspan-002. Tighten screws securely.
Note
The screws have two different head diameters. Use the screws with the smaller heads
on the standoffs next to VMEbus connectors P1 and P2.

MVME5100

Before installing the MVME5100 into your VME chassis, ensure that the jumpers are configured
properly. This procedure assumes that you have already installed the PMCspan(s) and any
PMCs that you have selected.
Perform the following steps to install the MVME5100 in your VME chassis:
Warning
Caution
1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an electrical
ground. Note that the system chassis may not be grounded if it is unplugged. The ESD
strap must be secured to your wrist and to ground throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power off and remove the
AC cord or DC power lines from the system. Remove chassis or system cover(s) as
necessary for access to the VME module.
3. Remove the filler panel from the VMEbus chassis card slot where you are going to
install the MVME5100. If you have installed one or more PMCspan PCI expansion
modules onto your MVME5100, you will need to remove filler panels from one
additional card slot for each PMCspan, above the card slot for the MVME5100.
Dangerous voltages, capable of causing death, are present in this equipment.
Use extreme caution when handling, testing, and adjusting.
Inserting or removing modules with power applied may result in damage to
module components. Avoid touching areas of integrated circuitry, static
discharge can damage these circuits.
– If you intend to use the MVME5100 as system controller, it must
occupy the left-most card slot (slot 1). The system controller must be
in slot 1 to correctly initiate the bus-grant daisy-chain and to ensure
proper operation of the IACK daisy-chain driver.
MVME51005E Single Board Computer Installation and Use (6806800A38B)
1 Hardware Preparation and Installation
11