Connectors; Ipmc761 Connector (J3) Pin Assignments; Table 6-1. Ipmc761 Connector Pin Assignments - Emerson MVME51005E Installation And Use Manual

6 Pin Assignments
Jumper
J4 Ethernet Port 2 Selection
(set in conjunction with
jumpers J10 and J17)
J6, J20 Operation Mode
(Set Both Jumpers)
J7 Flash Memory Selection
at Boot
J10, J17 Ethernet Port 2 Selection
(set in conjunction with jumper
J4)
J15 System Controller (VME)
J16 Soldered Flash Protection

Connectors

IPMC761 Connector (J3) Pin Assignments

This connetor is used to provide an interface to the IPMC761 module signals and is located near
J11. The pin assignments for this connector are as follows:

Table 6-1. IPMC761 Connector Pin Assignments

Pin
1 I2CSCL
3 GND
5 DB8#
7 GND
9 DB10#
11 +3.3V
13 DB12#
15 GND
17 DB14#
54
MVME51005E Single Board Computer Installation and Use (6806800A38B)
Description
Assignment
I2CSDA
GND
GND
DB9#
+3.3V
DB11#
GND
DB13#
+3.3V
Setting
For "P2" Ethernet Port 2:
Pins 1,2; 3,4; 5,6; 7,8 (set for
712/761)
For "Front Panel" Ethernet Port 2:
No Jumpers Installed
Pins 1,2 for PMC Mode
Pins 2,3 for SBC Mode (761 Mode)
Pins 1,2 for Soldered Bank A
Pins 2,3 for Socketed Bank B
For "Front Panel" Ethernet Port 2:
Pins 1,3 and 2,4 on Both Jumpers
For "P2" Ethernet Port 2:
Pins 3,5 and 4,6 on Both Jumpers
(set for 712/761)
Pins 1,2 for No SCON
Pins 2,3 for Auto SCON
No Jumper for ALWAYS SCON
Pins 1,2 Enables Programming of
Flash
Pins 2,3 Disables Programming of
the upper 64KB of Flash
Pin
2
4
6
8
10
12
14
16
18
Default
No
Jumper
Installed
(front
panel)
PMC
Mode
Socketed
Bank B
Front
Panel
Ethernet
Port 2
Auto
SCON
Flash
Prog.
Enabled