Tray 2 Service Check; 840.Xx Service Check - Dell 3333dn Service Manual

Tray 2 service check

FRU
Tray 2

840.xx service check

Step
1 POR the machine into configuration mode.
Go to the disable scanner menu item. See
"Disable Scanner" on page
"Enable ADF/FB -Enabled and press
Submit to save the change. POR the MFP
to operating mode. Try running a copy from
the ADF and flatbed.
Did the 840.xx error recur?
2 Re-enter Configuration mode, scroll to and
select the Disable Scanner menu item.
Does the screen display ADF Disabled or
Auto Disabled?
3 Check the ADF cable connections on the
ADF relay card and connector J17 on the
controller board. Also inspect the cable
connections on J28, J12, 13 and J30 on the
controller board.
Are the connections properly connected?
4 Properly connect the connections on the
ADF relay card and controller board. POR
the machine into configuration mode. Go to
the disable scanner menu item. See
"Disable Scanner" on page
"Enable ADF/FB -Enabled and press
Submit to save the change. POR the MFP
to operating mode. Try running a copy from
the ADF and flatbed.
Did the 840.xx error recur?
5 Check the continuity on the ADF cable.
Is there continuity?
Action
Turn the printer off.
Separate the printer from Tray 2.
Turn the printer on and check the voltages on connector J28 on the engine board.
Pins 1, 4: 3.3 V
Pin 2: 24 V
Pin 6: Ground
If the voltages are incorrect, then replace the engine board. If the voltages are correct, then
try using Tray 2 again. If the printer error persists, then replace Tray 2.
Questions / actions
3-36. Touch
3-36. Touch
Yes
Go to step 2.
Go to step 3.
Go to step 5.
Go to step 5.
Go to step 7
No
Stop. Problem resolved.
Go to step 8.
Go to step 4.
Stop. Problem solved.
Go to step 6.
2-55
Diagnostics information