Dell 3333dn Service Manual page 59

Hide thumbs Also See for 3333dn:
Table of Contents

Advertisement

Error
201.25
Exit sensor never made by leading edge of media
when feeding out the media that was detected during
warm-up.
201.26
Page at fuser nip before fuser started ramping toward
desired temperature. Indicates code may be receiving
more interrupts than intended
201.27
Page at fuser nip before fuser reached acceptable
operating temperature. Page arrived at fuser earlier
than expected, so it was probably staged prematurely.
202.00
Paper jam around exit sensor.
202.01
Exit sensor never broke on the trailing edge of the
sheet at the exit sensor.
202.02
Exit sensor never broke from sheet ahead of page
heading toward the exit sensor.
202.06
Exit sensor bounced
202.13
Exit sensor covered, media not expected (media not in
machine during warm-up)
202.25
Exit sensor never broke from the sheet ahead of the
page heading toward the exit sensor when feeding out
the media detected during warm-up.
202.26
Trailing edge never cleared exit sensor when feeding
out media that was detected during warm-up.
202.32
Long media or shingled multi feed stopped before
sending to duplex.
Description
Action
Remove the toner cartridge/PC kit and check for
obstructions between the input sensor and the fuser.
if the media continues to stop at the entrance or in
the fuser, then replace the fuser. See
removal" on page
4-28.
Open the rear cover and look for obstructions in the
path way. If there are none, then inspect for damage
at the fuser, rear door, exit guide, and top cover.
Often, the leading edge of the media will indicate the
vicinity of damage. If damage is found, then replace
the damaged part.
Note: Print a page with the rear door open to isolate
the fuser from the other parts.
Open the rear door, and inspect the flag on the exit
sensor. The flag is located behind the fuser exit
rollers, about mid printer. If the flag does not rotate
freely or has no spring action, then replace the fuser.
See
"Fuser removal" on page
Open the rear door, and inspect the flag on the exit
sensor. The flag is located behind the fuser exit
rollers, about mid printer. If the flag does not rotate
freely or has no spring action, then replace the fuser.
See
"Fuser removal" on page
Check the paper setting and correct if needed. While
feeding along the media, and immediately after it
enters the output bin, open the rear door and
obscure the trailing edge and the sensor flag. If there
is slippage in the exit guide, then replace the exit
guide. See Go to
"Rear exit guide assembly with
sensor and reversing solenoid removal" on
page
4-75.
Diagnostics information
"Fuser
4-28.
4-28.
2-23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

3335dn

Table of Contents