Partial Blank Image/White Spots (No Repeating Pattern); Variation In Image Density Horizontally Across Page; Poor Fusing Of Image - Dell 3333dn Service Manual

Partial blank image/white spots (no repeating pattern)

FRU
Toner cartridge (not a
FRU)
Paper (not a FRU)

Variation in image density horizontally across page

FRU
PC Kit (not a FRU)
Transfer roll

Poor fusing of image

FRU
Fuser
Media (not a FRU)
Action
Remove the toner cartridge assembly, and gently shake the assembly to evenly distribute
the toner.
Check to make sure that the laser light path is not blocked.
If toner cartridge is low, then try a new one.
Make sure recommended media is being used.
Check the media settings in the printer driver. A heavier media may require higher heat to
properly fuse.
Action
The charge roll may have an unbalanced force against the PC (photoconductor) drum.
Try a new PC Kit.
Note: Do not touch the transfer roll except at its ends. Place a sheet of paper over the roll to
prevent damage from finger oils or hand lotion.
Check the springs in the left and right transfer roll bearings. The bearing assemblies should
support the transfer roll, applying evenly distributed forces to the PC drum.
Replace the transfer roll assembly if the springs or bearings show signs of damage, or
fatigue.
Inspect the transfer roll for signs of wear, damage or contamination.
Replace as necessary.
Action
The fuser may not be operating at the proper temperature to fuse the toner to the paper.
See"LVPS/HVPS service check" on page 2-39
setting to heavier paper or even card stock.
Make sure recommended media is being used.
Check the media settings in the printer driver.
for more information. Try changing the
Diagnostics information
2-49