Dell 3333dn Service Manual page 68

Fax error log codes (Continued)
Error code
7XX
800
802
803
804
805
808
809
80A
80B
80C
80D
80E
811
812
2-32
Service Manual
Description
Error occurred when sending a frame.
Received EOT unexpectedly from
the modem in V34 mode.
Too many timeouts occurred
during ECM reception.
Fax cancelled by user
Unexpectedly received a disconnect
command from the remote end.
Remote fax device failed to respond to
the DCS command.
T1 timeout occurred when trying to
establish a connection with a remote
fax device.
T2 Timeout occurred due to loss of
command/response synchronization.
T5 Timeout occurred when transmitting
image data to remote fax device.
Too many errors when transmitting in
ECM mode.
Remote device failed to respond to the
CTC command.
Received too many requests from
remote end to repeat the previous
command sent.
Functional limitation- Remote fax
device does not support G3 receive
capability.
Failed to detect a fax device at the
remote end.
No more data rates available in V34
modulation scheme.
Action
• Check line quality.
• Adjust 'Transmit Level'.
• Select a lower 'Max Speed' value
under Fax Send settings.
• If error persists disable V34 modulation
scheme.
• If error persists disable ECM mode.
No action needed.
• Check line quality.
• Adjust Transmit Level/Receive
Threshold values.
• Remote device could be requesting an
unsupported feature.
• Adjust Transmit Level/Receive
Threshold values.
• Remote device could be
malfunctioning.
• Adjust Transmit Level/Receive
Threshold values.
• Adjust Transmit Level/Receive
Threshold values.
• Check line quality.
• Adjust 'Transmit Level'.
• Select a lower 'Max Speed'value under
Fax Send settings.
• Check line quality.
• Adjust 'Transmit Level'.
• Select a lower 'Max Speed'value under
Fax Send settings.
• Select a lower 'Max Speed' value
under Fax Send settings.
• Adjust 'Transmit Level'.
• Check line quality.
• Adjust 'Transmit Level'.
• Check if line conditions on remote end
will facilitate a good connection.
No action needed. Issue with the remote
device.
• Verify MFD is answering to fax call and
not a voice call.
• Decrease value of 'Rings To Answer'
setting.
• Adjust to a lower modulation scheme.