Dell 3333dn Service Manual page 57

Error
200.13 The input sensor is covered when the media is not
expected (media in machine during warm-up)
200.14 Trailing edge cleared manual feed, but did not
successfully debounce the sensor. Potential causes
are a small gap or a bouncy manual feed sensor.
200.15 UNRECOVERABLE NO GAP JAM. Engine detected
no gap at the manual feeder sensor, attempted to open
the gap by stopping the feed rolls, but no trailing edge
was ever seen at the input sensor.
200.16 Transport motor error detected
200.17 Took too long to ramp up transport motor
200.18 Manual feeder sensor never became uncovered from
the sheet ahead.
200.19 The media never reached the input sensor, but was
detected at manual feeder sensor.
200.20 The media is too long over the manual feeder sensor.
Possible causes include multi-sheet feed, media size
(length) problem, pre-staged media in the tray.
200.22 FAILED SMALL GAP OR NO GAP JAM RECOVERY.
Engine detected small gap or no gap at the manual
feeder sensor, opened the gap by stopping the feed
rolls, but never saw the leading edge of the second
page at the input sensor.
200.23 Laser Servo never started due to potential conflict with
the transfer servo. Possible causes: slow or missing
transport motor positional feedback, or the media is
transferred too quickly to the input sensor.
200.24 The measured gap at the input sensor is too small to
meet the video delivery requirements. (There is not
enough time since prior image finished to start new
image)
200.26 The trailing edge never cleared the input sensor when
feeding out the media that was detected during warm-
up.
200.27 Printhead Driver: Mirror motor fell out of lock condition
after the media at the input sensor–more time elapsed
since the printhead than the expected stable lock time,
but less than the printhead jitter-stable specification.
Mirror motor fell out of lock condition after media at the
input sensor–more time elapsed since the printhead
than expected stable lock time, but less than the
printhead jitter-stable specification.
Description Action
Remove the toner cartridge/PC kit and inspect the
input sensor flag. Replace the flag if necessary.
Remove the toner cartridge/PC kit. At the front,
remove the upper front guide, and inspect the flag on
the manual input sensor. If the flag is loose, then
replace it. See "Media manual input sensor" on
page 2-52.
Remove the toner cartridge/PC kit. At the front,
remove the upper front guide, and inspect the flag on
the manual input sensor. If the flag is loose, then
replace it. See "Media manual input sensor" on
page 2-52.
Verify that the media is approved. Inspect the wear
strips in the input tray, and replace if necessary.
Inspect the main motor. See
check" on page 2-40.
Remove the toner cartridge/PC kit. At the front,
remove the upper front guide, and inspect the flag on
the manual input sensor. If the flag is loose, then
replace it. See "Media manual input sensor" on
page 2-52.
Remove the toner cartridge/PC kit, and inspect for
debris in the paper path. Check the bottom of the PC
kit for any obstructions. Remove the upper front
guide, and inspect the pinch rollers.
Verify that the media is approved. Inspect the wear
strips in the tray, and replace if they are worn.
Verify that the media is approved. Inspect the wear
strips in the tray, and replace if they are worn.
Check the main motor. See
check" on page 2-40.
Verify that the media is approved. Inspect the wear
strips in the tray, and replace if they are worn.
Check the printhead. See
check" on page 2-54.
Diagnostics information
"Main motor service
"Main motor service
"Printhead service
2-21