Factory Defaults; Energy Conserve; Min Copy Memory - Dell 3333dn Service Manual

Factory Defaults

Warning: This operation cannot be undone.
This setting enables you to restore all of the printer's settings to the base printer settings, the network settings, or
to remove all LXK Embedded Solutions (LES) applications.
To restore the Factory Default settings:
1. Touch Factory Defaults from the Configuration Menu.
2. Touch Restore Base to restore all non-critical base printer NVRAM settings.
3. Touch Restore Network to restore all network NVRAM settings.
4. Touch Restore LES to remove all LXK Embedded Solution applications
When you select either value, the LCD displays Restoring Factory Defaults and then Resetting the Device. The
device immediately performs a POR and restores the appropriate settings to their factory default values.
The following settings are not changed:
•
Display Language (general settings)
•
Network/Ports Menu
•
Standard USB, USB (x) Menus (if an ENA is installed)

Energy Conserve

This menu controls what values appear on the Power Saver menu. If Off is selected in the Energy Conserve
menu, then Disabled appears in the Power Saver menu, and Power Saver can be turned off. If On is set in the
Energy Conserve menu, the Power Saver feature cannot be disabled.
To change this setting:
1. Touch Energy Conserve from the Configuration Menu.
touch-screen.
2. Touch or
3. Touch Back to cancel and return to the Configuration Menu.
4. Touch Submit to save the change.

Min Copy Memory

Values will only be displayed if the amount of installed DRAM is at least twice the amount of the value, that is, at
least 200 MB of installed DRAM is required to display the 100 MB selection.
To change this setting:
1. Touch Min Copy Memory from the Configuration Menu.
touch-screen.
2. Touch to decrease the setting's value; touch
3. Touch Back to cancel and return to the Configuration Menu.
4. Touch Submit to save the change.
3-6
Service Manual
to scroll through the setting's possible values.
.
[setting's current value]
[setting's current value]
to increase the setting's value.
appears on the
appears on the