Installation; Appropriate Installation Location; Removing Packaging Reinforcement; Removing The Transportation Locks - Grundig GWN 47230 User Manual

3

Installation

Refer to the nearest Authorised Service Agent
for installation of the product. To make the
product ready for use, review the information
in the user manual and take care that the
electricity, tap water supply and water
drainage systems are appropriate before
calling the Authorized Service Agent. If
they are not, call a qualified technician and
plumber to have any necessary arrangements
carried out.
C
Preparation of the location and
electrical, tap water and waste water
installations at the place of installation is
under customer's responsibility.
B
WARNING:
and electrical connections of the
product made by the Authorized
Service Agent. Manufacturer shall not
be held liable for damages that may
arise from procedures carried out by
unauthorized persons.
A
WARNING:
visually check if the product has any
defects on it. If so, do not have it
installed. Damaged products cause risks
for your safety.
C
Make sure that the water inlet and
discharge hoses as well as the power
cable are not folded, pinched or
crushed while pushing the product into
its place after installation or cleaning
procedures.
3.1 Appropriate
installation location
ĥ Place the product on a rigid floor. Do
not place it on a long pile rug or similar
surfaces.
Total weight of the washing machine and
ĥ
the dryer -with full load- when they are
placed on top of each other reaches to
approx. 180 kilograms. Place the product
on a solid and flat floor that has sufficient
load carrying capacity!
Do not place the product on the power
ĥ
cable.
ĥ Do not install the product at places where
temperature may fall below 0ºC.
ĥ Place the product at least 1 cm away from
the edges of other furniture.
Washing Machine / User's Manual
Have the installation
Prior to installation,
3.2 Removing packaging
reinforcement
Tilt the machine backwards to remove
the packaging reinforcement. Remove the
packaging reinforcement by pulling the ribbon.
3.3 Removing the
transportation locks
A
WARNING:
transportation locks before taking out
the packaging reinforcement.
A
WARNING:
transportation safety bolts before
operating the machine! Otherwise, the
product will be damaged.
Loosen all the bolts with a suitable spanner
ƒ1
until they rotate freely (C).
ƒ2 Remove transportation safety bolts by
turning them gently.
Do not remove the
Remove the
55 / 92 EN