Table of Contents
Advertisement
Installation
To make the product ready for
use, review the information in the
user manual and make sure that
the electricity, tap water supply
and water drainage systems are
appropriate. If they are not, call a
qualified technician and plumber to
have any necessary arrangements
carried out.
C
Preparation of the location
and electrical, tap water and
waste water installations
at the place of installation
is under customer's
responsibility.
B
WARNING: Installation and
electrical connections of
the product must be carried
out by competent persons.
Manufacturer shall not be
held liable for damages that
may arise from procedures
carried out by unauthorized
persons.
A
WARNING: Prior to
installation, visually check
if the product has any
defects on it. If so, do not
have it installed. Damaged
products cause risks for
your safety.
C
Make sure that the water
inlet and discharge hoses
as well as the power cable
are not folded, pinched or
crushed while pushing the
product into its place after
installation or cleaning
procedures.
12
Appropriate installation location
• Place the machine on a rigid floor.
Do not place it on a long pile rug
or similar surfaces.
• Total weight of the washing
machine and the dryer -with full
load- when they are placed on top
of each other reaches to approx.
180 kilograms. Place the product
on a solid and flat floor that has
sufficient load carrying capacity!
• Do not place the product on the
power cable.
• Do not install the product at
places where temperature may
fall below 0ºC.
• Leaving a gap at the sides of the
machine is suggested to reduce
vibration and noise
• Do not place heat sources such
as Hobs, Irons, Ovens, etc. on the
washing machine and do not use
them on the product.
Removing packaging
reinforcement
Tilt the machine backwards
to remove the packaging
reinforcement. Remove the
packaging reinforcement by pulling
the ribbon.
Advertisement
Table of Contents
