Table of Contents
Advertisement
4.4 Installation
• Apply to the nearest authorized service agent for the installation of your product.
• Preparation of the location and electrical, tap water and waste water
installations at the place of installation is under customer's responsibility.
• Make sure that the water inlet and discharge hoses as well as the power cable
are not folded, pinched or crushed while pushing the product into its place after
installation or cleaning procedures.
• Make sure that the installation and electrical connections of the product are
performed by authorized service. Manufacturer shall not be held liable for
damages that may arise from procedures carried out by unauthorized persons.
• Prior to installation, visually check if the product has any defects on it. If so, do
not have it installed. Damaged products cause risks for your safety.
4.4.1 Appropriate installation location
• Place the product on a hard and level floor. Do not put it onto a carpet with high
pile or other similar surfaces.
• When the washing machine and drier are placed on top of each other, their
total weight –when loaded– amounts to 180 kilograms. Place the product on a
solid and flat floor that has sufficient load carrying capacity!
• Do not place the product on the power cable.
• Do not install the product in the environments where the temperature falls below
0 ºC.
• Leave a minimum space of 1 cm between the machine and the furniture.
• If you will install the product on a surface with steps, never put it on place near
the edge.
• Do not place the product on any platform.
4.4.2 Removing packaging reinforcement
12 / EN
Tilt the product backwards to remove the packaging
reinforcement. Remove the packaging reinforcement by
pulling the ribbon. Do not make this operation alone
by yourself.
Washing Machine / User's Manual
Advertisement
Table of Contents
