Connecting To The Drain; Adjusting The Feet - Grundig GWN 47230 User Manual

Installation

3.5 Connecting to the drain

ĥ Connect the end of the drain hose directly
to the wastewater drain, sink or to the
washbasin.
A
WARNING:
flooded if the hose comes out of its
housing during water discharge.
Moreover, there is risk of scalding
due to high washing temperatures! To
prevent such situations and to ensure
smooth water intake and discharge of
the machine, fix the end of the discharge
hose tightly so that it cannot come out.
Attach the hose at a height of at least 40
ĥ
cm, and 100 cm at most.
ĥ In case the hose is elevated after laying
it on the floor level or close to the ground
(less than 40 cm above the ground), water
discharge becomes more difficult and the
laundry may come out excessively wet.
Therefore, follow the heights described in
the figure.
To prevent flowing of dirty water back
ĥ
into the machine and to allow for easy
discharge, do not immerse the hose end
into the dirty water or do not drive it in the
drain more than 15 cm. If it is too long, cut
it short.
Pay care not to bend the end of the hose,
ĥ
step on it or pinch the hose between the
drain and the machine.
If the length of the hose is too short, use
ĥ
it by adding an original extension hose.
Length of the hose may not be longer than
3.2 m. To avoid water leak failures, the
connection between the extension hose
and the drain hose of the product must be
fitted well with an appropriate clamp as
not to come off and leak.
Washing Machine / User's Manual
Your house will be

3.6 Adjusting the feet

A
WARNING:
that the product operates more silently
and vibration-free, it must stand level
and balanced on its feet. Balance
the machine by adjusting the feet.
Otherwise, the product may move from
its place and cause crushing, noise and
vibration problems.
Loosen the lock nuts on the feet by hand.
ƒ1
Adjust the feet until the product stands level
ƒ2
and balanced.
Tighten all lock nuts again by hand.
ƒ3
A
WARNING:
to loosen the lock nuts. Otherwise, they
will get damaged.
In order to ensure
Do not use any tools
57 / 92 EN