Connecting To The Water Supply - Grundig GWN 47230 User Manual

Installation
Attach the plastic covers supplied in the
ƒ3
User Manual bag into the holes on the
rear panel. (P)
C
Keep the transportation safety bolts in
a safe place to reuse when the washing
machine needs to be moved again in
the future.
C
Never move the product without the
transportation safety bolts properly fixed
in place!
3.4 Connecting to the
water supply
C
The water supply pressure required to
run the product is between 1 to 10 bars
(0.1 – 10 MPa). It is necessary to have
10 – 80 liters of water flowing from the
fully open tap in one minute to have your
machine run smoothly. Attach a pressure
reducing valve if water pressure is higher.
C
If you are going to use the double water-
inlet product as a single
inlet unit, you must install the supplied
stopper to the hot water valve before
operating the product. (Applies for the
products supplied with a blind stopper
group.)
A
WARNING:
water inlet should not be connected to
the hot water tap. In such a case the
laundry will get damaged or the product
will switch to protection mode and will
not operate.
A
WARNING:
water inlet hoses on the new product. It
may cause stains on your laundry.
56 / 92 EN
(cold)
water-
Models with a single
Do not use old or used
Connect the special hoses supplied with
ƒ1
the product to the water inlets on the
product. Red hose (left) (max. 90 ºC) is for
hot water inlet, blue hose (right) (max. 25
ºC) is for cold water inlet.
A
WARNING:
hot water connections are made correctly
when installing the product. Otherwise,
your laundry will come out hot at the end
of the washing process and wear out.
Tighten all hose nuts by hand. Never use a
ƒ2
tool when tightening the nuts.
Open the taps completely after making
ƒ3
the hose connection to check for water
leaks at the connection points. If any leaks
occur, turn off the tap and remove the nut.
Retighten the nut carefully after checking
the seal. To prevent water leakages and
damages caused by them, keep the taps
closed when the machine is not in use.
Washing Machine / User's Manual
Check that the cold and