Grundig GWN 47230 User Manual page 83

Maintenance and cleaning
In addition, prior to transporting the machine
(e.g., when moving to another house) and in
case of freezing of the water, water may have
to be drained completely.
A
WARNING:
left in the pump filter may damage your
machine or may cause noise problem.
A
WARNING:
use, turn the tap off, detach the supply
hose and drain the water inside the
machine against any freezing possibility
in the region of installation.
A
WARNING:
the supply hose tap of the product.
In order to clean the dirty filter and discharge
the water:
Unplug the machine to cut off the supply
ƒ1
power.
A
WARNING:
water inside the machine may rise up
to 90 ºC. To avoid burning risk, clean
the filter after the water in the machine
cools down.
Open the filter cap.
ƒ2
ƒ If the filter cap is composed of two pieces,
press the tab on the filter cap downwards
and pull the piece out towards yourself.
Washing Machine / User's Manual
Foreign substances
If the product is not in
After each use close
Temperature of the
If the filter cap is one piece, pull the cap from
both sides at the top to open.
C
You can remove the filter cover by
slightly pushing downwards with a thin
plastic tipped tool, through the gap
above the filter cover. Do not use metal
tipped tools to remove the cover.
Some of our products have emergency
ƒ3
draining hose and some does not have.
Follow the steps below to discharge the
water.
If the product has an emergency
draining hose, to discharge the water:
Pull the emergency draining hose out from
ƒa
its seat
ƒb Place a large container at the end of the
hose. Drain the water into the container
by pulling out the plug at the end of the
hose. When the container is full, block the
inlet of the hose by replacing the plug.
After the container is emptied, repeat the
above procedure to drain the water in the
machine completely.
83 / 92 EN