CyberData 011098 Series Operation Manual page 37

2. On the SIP Configuration page, you may enter values for the parameters indicated in
Web Page Item
Enable SIP Operation
SIP Settings
SIP Server
Backup SIP Server 1
Backup SIP Server 2
SIP Server
Remote SIP Port*
Local SIP Port*
Outbound Proxy
Outbound Proxy Port
SIP User ID*
Authenticate ID*
Authenticate Password*
Register with a SIP Server*
Re-registration Interval (in seconds)*
Unregister on Reboot*
Buffer SIP Calls
Beep on Page
Operations Guide
Table 2-8. SIP Configuration Parameters
Description
Enables or disables SIP operation.
Use this field to set the address (in dotted decimal notation or as
a canonical name) of the SIP registrar. This field can accept
canonical names of up to 255 characters in length.
When the primary SIP Server goes offline and the device fails to
register after the normal re-registration interval, the controller
will fall back to using Backup SIP Server 1.
If Backup SIP Server 1 fails, the device will use Backup SIP
Server 2.
If a higher priority SIP Server comes back online, the device will
switch back to this server.
You can leave the Backup SIP Server 1 and Backup SIP
Server 2 fields blank.
Use this field to set the address (in dotted decimal notation or as
a canonical name) of the SIP registrar. This field can accept
canonical names of up to 255 characters in length.
Type the Remote SIP Port number (default 5060) 
(8 character limit).
Type the Local SIP Port number (default 5060) 
(8 character limit).
Type the Outbound Proxy as either a numeric IP address in
dotted decimal notation or the fully qualified host name 
(255 character limit [FQDN]).
Type the Outbound Proxy Port number (8 character limit).
Type the SIP User ID (up to 64 alphanumeric characters).
Type the Authenticate ID 
(up to 64 alphanumeric characters).
Type the Authenticate Password (up to 64 alphanumeric
characters).
Enable or disable SIP Registration.
Type the SIP Registration lease time in minutes (default is 60
minutes) (8 character limit). Re-registration Interval (in
seconds)*
When selected, on boot, the speaker will first register with a SIP
server with a expiration delay of 0 seconds. This has the effect
of unregistering any current devices on this extension.
When this is enabled, SIP calls to the speaker will be stored in
memory and will play when either the call is terminated or the
buffer is full. The receive buffer is 2MB in size and this is equal
to about four minutes of ulaw encoded audio.
When selected, the device will play a beep before a page is sent
on SIP calls (works for both buffered and live pages).
930274O
Installing the VoIP V2 Speaker
Configure the SIP Parameters
Table 2-8.
CyberData Corporation
29