Web Configuration Utility; Web Configuration Utility; Examples - Digital Projection E-Vision 8000 Series User Manual

Digital Projection
E-Vision 8000 Series

Web Configuration Utility

The LAN IP Address of the projector can be set remotely using the Web Configuration Utility.
•
Make sure the projector is connected to a remote computer via LAN.
•
From the remote computer, access the default LAN IP address of the projector. The Web Configuration Utility opens.
It is possible to control many of the projector's settings using the embedded Web Configuration Utility. The following pages contain a few
examples of such settings.

Examples

Navigate to the Control tab and edit the settings as required.
The Source/general page enables you to:
•
switch the projector on and off
•
open and close the shutter
•
select an input source
Rev F July 2014

WEB CONFIGURATION UTILITY

Remote Communications Guide
Notes
must be set to
Eco Network Power
Standard , if you wish to control the
projector via the LAN connection.
The default LAN IP address is
192.168.0.100
If you suspect this has been
changed, then you can view the
current Network settings in the
Control Menu .
For more information about
connecting the projector via LAN,
see the Connection Guide.
66