Natural Gas - Cal Flame BBQ08873P Owner's Manual

12

Natural Gas

Requirements
Always check the rating plate to make sure the gas
supply you are hooking up to is the gas type the grill
is manufactured for.
IMPORTANT: Never connect the grill to an unregu-
lated gas supply.
The installation of this appliance must conform with
local codes or, in the absence of local codes, to the
national fuel gas code, ANSI Z223.1a-1998. Installa-
tion in Canada must be in accordance with the stan-
dard CAN/CGA-B149.2, Propane Installation Code.
A licensed contractor or local gas company represen-
tative must perform all natural gas connections.
Ensure that the service supplying the grill is fitted
with a shut off valve conveniently positioned near the
grill and giving ease of access.
The grill must be isolated from the gas supply piping
system by closing its individual manual shutoff valve
during any pressure testing of the gas supply piping
system at test pressures equal to or less than 0.5 psi
(3.5 kPa).
The grill and its individual shutoff valve must be dis-
connected from the gas supply piping system during
any pressure testing of that system at test pressure
in excess of 0.5 psi (3.5 kPa).
Your Cal Flame™ grill for use with natural gas comes
equipped with its own regulator that MUST NOT be
removed. If, this regulator needs to be replaced use
only the type specified by Cal Flame™ for this appli-
ance.
www.calflamebbq.com
Connection
1. Slide the grill forward to gain access to the regu-
lator and gas connection point in the rear.
2. Remove the rear panel from the barbecue to
gain access to the regulator and gas connection
point.
3. Connect a suitable flex connector to the grill reg-
ulator.
4. Check the grill controls to ensure all control valves
are in the full OFF position.
5. Turn on the main gas supply and check all con-
nections for leaks using soapy water as described
in the leak testing procedure section.
Warning: If you see bubbles in the soapy solution at
any of the connections, turn off the gas supply and
tighten the connection. If tightening the connection
does not seal the leak, it may be necessary to replace
the flex hose.
Barbecue Grills
LTR50001038, Rev. B