Troubleshooting - Cal Flame BBQ08873P Owner's Manual

Troubleshooting

Appendix
Problem: Smell of gas is present
Solution: Check for loose connections in the gas line. Perform a leak test following the procedure
described in this manual.
Problem: Burner does not ignite
Solution:
Note: Turn off the gas at the source while troubleshooting.
Use the following procedure with the figure below.
Check the position of the sparker tip. It should be pointing forward towards the front of
the burner.
• Make sure there is a blue spark at the electrode tip to the burner.
• Make sure the igniter wire is connected firmly to the valve ignition device and the
electrode.
• Make sure the valve orifice is free of any debris, dust or grease.
• Make sure the valve orifice is aligned inside the front hole of the burner.
• If there is no spark at all, replace the electrode or igniter wire.
Problem: Burner tube is misaligned over the orifice
Solution: Reposition the burner tube so that it is properly seated over the orifice.
Problem: Obstruction in the gas line
Solution:
Remove the fuel line from grill. (Do not smoke or perform any maintenance in the vicinity
of an open flame.) Open the gas valve for one second to blow out any debris. Close off
the gas valve and reconnect the fuel line securely. Let the area ventilate for a few seconds
before reconnecting the fuel line.
Barbecue Grills
LTR50001038, Rev. B
23
www.calflamebbq.com