ATV ATV110-M Service Manual page 62

-56-
5.Inspection of rear wheel axle ¢Ù
a:If the rear wheel axle is heavily scraped or
broken, replace it.
b.If the thread or gear groove on the rear wheel
axle is worn or damaged, replace it.
6.Measurement
The radial runout of the pisition @on the rear
wheel axle, if out of specification, repalce it.
Attached:The radial runout limit of rear wheel
axle:1.5mm
Warning
If the axle is bent, do not straighten it forcefully.
7. Check
¢ÙRear brake suppont
¢ÚIf there is any erack or friction is the
suppont, replace it.
8. Inspection
(1) Bearing
Rotate the rear wheel axle, if the axle shakes
left and right in the bearing or runout axilaay,
It indicated that the bearing is heavily worn
needing to be replaced.
(2) Oil seal
If the oil seal is worn or damaged, replace it.
Caution
During the install ment, the prsessing tool of
bearing should be matched with the outer di-
ameter of bearing outer race and that of oil
seal.
Warning
Never beat the inner race and bearing ball, the
pressing tool needs to touch with bearing outer
reac.