Log Event Codes; Reset User Code 1; Start Call Back; Press Ent To Reset User - Menvier Security TS590 Installation & Programming Manual

Engineer's Menu 2

Log Event Codes

LCD
PANEL LID TAMPER
PART SET A/B/C
PASSCODE 00-15
REINSTATEMENT
RELEARN REQUIRED
REM REMOVED 01-04
REM SERVICE CALL
REM TAMPER 01-04
REMOTE ADDED 01-04
REMOTE RESET
SERVICE CALL END
SERVICE REQUIRED
SET FAIL
SYSTEM OPEN
SYSTEM RE-ARMED
SYSTEM SET
TAMPER 00
TAMPER 01-14
TEST CCTS OFF
TEST FAIL 01-14

Reset User Code 1

This option allows the installation engineer to reset
the master user (user 01) back to the factory
default code of "5678". This feature is useful when
the master user has forgotten their passcode or
has accidentally changed it without realising. This
operation is logged.
Reset User Code Flowchart
40
Control panel lid removed.
System Part-Set using one of the A, B, or C buttons.
User passcode entered. (00-15).
Time and date for reinstatement.
Hardware relearn required see page 34.
Remote Keypad removed from system.
Remote service call via "Lineload" software and PC.
Remote Keypad cover removed.
Remote Keypad added to the system.
System reset by "Remote Reset" passcode.
Remote service call finished.
Service required
System failed to Set.
System fully unset.
System re-armed all healthy circuits.
System fully set.
Short circuit on ID loop.
Tamper alarm from circuit.
All circuits taken off "Test"
Circuit failed during "Test".
LCD
Engineers menu 2
Select Option :-
0
Press ENT to
Reset User 1 ?
ENT
to reset user 1
Description
[2.0]

Start Call Back

If the system is fitted with a digi-modem, it is
possible for the installation engineer to initiate an
upload sequence to a remote site (normally the
alarm company). Once the communication link is
established with the remote site, data can be sent
and received from the control panel. This feature is
only compatible with Menvier Lineload software
version 2.5 or above.
TS590 Installation Manual
[2.A]