Installing At-Stat - Allied Telesis AT-2400 Series Installation Manual

AT-Stat

Installing AT-Stat

82
To install AT-Stat, perform the following procedure:
Note
The adapter driver for an AT-2450, AT-2451, AT-2500, AT-2501,
AT-2700, or AT-2701 Series network adapter card must be updated
to obtain custom statistics. Otherwise, only generic statistics are
available. To update an adapter driver, refer to
Adapter Driver on page 55.
1. Insert the CardAssistant CD into the CD-ROM drive.
The CardAssistant Main Menu shown in Figure 59 is displayed. If this
menu is not displayed, double-click on the My Computer icon, then
double-click on the Allied Telesyn CD-ROM icon.
Figure 59 CardAssistant CD Main Menu
2. From the Driver Setup drop-down menu, select the adapter card
that you purchased.
Updating a Network