Windows Nt 4.0 - Allied Telesis AT-2400 Series Installation Manual

Manually Installing a Network Adapter Driver

Windows NT 4.0

48
This section contains the procedure for manually installing a network
adapter driver in a Windows NT 4.0 operating system. The AT-2801FX,
AT-2916T, AT-2970, and AT-2971 Series Adapters are currently not
available for Windows NT 4.0. Please check Allied Telesyn's website at
www.alliedtelesyn.com
Note
You should review the
performing the following procedure.
1. Shutdown Windows NT and power OFF the computer.
2. Install the network adapter card. Refer to
Adapter Card on page 13 and the documentation that came with
your computer for instructions.
3. Power ON the computer.
4. From the desktop, click Start.
5. Select Settings, then select Control Panel, as shown in Figure 28.
for updates.
Installation Guidelines
Figure 28 Start Menu
on page 30 before
Installing the Network