For The At-2801Fx - Allied Telesis AT-2400 Series Installation Manual

To run diagnostics, perform the following procedure:
1.
2.
For the
The AT-2801FX is a CardBus PC Card that must be inserted into a
CardBus slot. If you are unable to insert an AT-2801FX into your PC, it
AT-2801FX
may not support a CardBus device. If you are unsure if your computer
will support a CardBus interface, contact your PC manufacturer to
determine if your computer supports CardBus Type II devices.
Allied Telesyn supplies a Windows Utility, AT-Stat, to verify network
adapter operation. Refer to
how to use this utility.
Note
Diagnostics is a DOS based program and must be run in true DOS,
not in a DOS shell within Windows.
If ON, power OFF your computer and reboot into DOS mode.
At the DOS prompt and without the drivers loaded, type diag.exe.
The location of the diagnostic files on the CardAssistant CD are:
Adapter Card
AT-2400 Series
AT-2500, AT-2501 Series
AT-2450, AT-2700,
AT-2701, AT-2745,
AT-2746 Series
AT-2915, AT-2930 Series
For example, if you want to run diagnostics for an AT-2500 Series
adapter card and the CD is mapped to drive D, you would enter:
D:\drivers\at2500\diag\diag25.exe
If you are using a driver installation disk, the diagnostic files are
stored in the root directory on the disk.
Network Adapter Card Installation Guide - Book I
Diagnostic Location
\drivers\at2400\diag\diag24.exe
\drivers\at2500\diag\diag25.exe
\drivers\at24_27\diag\diag.exe
\drivers\at29xx\diag\diag29.exe
AT-Stat on page 79 for more information on
109