System Requirements; Installing At-Stat - Allied Telesis AT-2400T Installation Manual

System
Requirements

Installing AT-Stat

To run AT-Stat, your system must be operating in either Windows 2000
or XP and have an Allied Telesyn network adapter card and driver
installed.
To install AT-Stat, perform the following procedure:
Note
The adapter driver for an AT-2450, AT-2500, AT-2501, AT-2700, or
AT-2701 Series network adapter card must be updated to obtain
custom statistics. Otherwise, only generic statistics are available. To
update an adapter driver, refer to
Driver on page 57.
1. Insert the CardAssistant CD into the CD-ROM drive.
The CardAssistant Main Menu shown in Figure 59 is displayed. If this
menu is not displayed, double-click on the My Computer icon, then
double-click on the Allied Telesyn CD-ROM icon.
Figure 59 CardAssistant CD Main Menu
2. From the Driver Setup drop-down menu, select the adatper card
that you purchased.
Network Adapter Card Installation Guide
Updating a Network Adapter
83