Installing An At-2801Fx - Allied Telesis AT-2400 Series Installation Manual

7.
8.
9.
10. Power ON the PC.
You are now ready to install the network adapter driver. You can install a
network adapter driver by performing either of the following
procedures:
Network Adapter Driver
Installing an
The AT-2801FX is a CardBus PC Card that must be inserted into a
CardBus slot. If you are unable to insert an AT-2801FX into your PC, it
AT-2801FX
may not support a CardBus device. If you are unsure if your computer
will support a CardBus interface, contact your PC manufacturer to
determine if your computer supports CardBus Type II devices.
For the AT-2450, AT-2500, or AT-2700 Series adapters, to use the
adapter card's Wake-on-LAN feature in your computer using an
Advanced Configuration and Power Interface (ACPI), you must
connect the Wake-on-LAN cable to the Wake-on-LAN connector on
the adapter card and to the Wake-on-LAN connector on the
motherboard of the computer. For the location of the Wake-on-LAN
connector on the motherboard, refer to the documentation that
came with your computer.
The AT-2501, AT-2451F, AT-2701, AT-2915, AT-2916T, AT-2930, and
AT-2971 do not require the optional external Wake-on-LAN cable.
These devices are PCI 2.2 compliant and can use the PCI 2.2 BUS for
Wake-on-LAN features.
Replace the PC's cover and secure it with the screws removed in
Step 2.
Connect the adapter card to the network by connecting the
appropriate data cable.
Running AT-Setup
on page 29.
Network Adapter Card Installation Guide - Book I
on page 22 or Manually Installing a
17