Hardware Installation - Lancom 1711+ VPN Manual

LANCOM 821+ – LANCOM 1711+ VPN – LANCOM 1721+ VPN
Chapter 2: Installation

2.4

Hardware installation

The installation of the LANCOM Router base station takes place in the follow-
ing steps:

821+/1721 only
1711+ only
22
Reset-or-boot (standard setting): Press the button briefly to re-start
the device. Pressing the button for 5 seconds or longer restarts the
device and resets the configuration to its factory settings.
All LEDs on the device light up continuously.
Once the switch is released the device will restart with the restored
factory settings.
After resetting, the device starts completely unconfigured and all set-
tings are lost. If possible be sure to backup the current device config-
uration before resetting.
LAN – connect the LANCOM Router to your LAN or to an individual PC.
For that purpose, plug the included network cable (green plugs) into the
LAN connector of the device
connecting socket of your local network, into a free socket of a hub/switch
or into the network socket of an individual PC.
The LAN connector identifies automatically the transfer rate (10/100
Mbps) of the connected network device (autosensing). A parallel connec-
tion of devices with different speeds and types is possible.
You should never have more than one unconfigured LANCOM Router
in a network segment at any given time. All unconfigured LANCOM
Router devices use the same IP address (with the final digits '254'),
which would result in an address conflict. To avoid problems, always
configure multiple LANCOM Router devices one at a time, immedi-
ately assigning each device a unique IP address (one that does not
end with '254').
ADSL – connect the ADSL interface
ADSL connector cable (transparent plugs).
DSL – connect the WAN interface
supplied DSL connector cable (dark blue plugs).
ISDN – to connect the LANCOM Router to the ISDN, plug one end of the
supplied ISDN connector cable (light blue plugs) in the ISDN/S
»
and the other end into a free network
to the splitter using the supplied
¿
to the DSL modem socket using the
²
port
0