Table of Contents
Advertisement
2.4
Hardware installation
The installation of the LANCOM Router base station takes place in the follow-
ing steps:
1811 only
1821+ only
1821+ only
LANCOM 1811 Wireless DSL – LANCOM 1821+ Wireless ADSL
Note that resetting the device leads to a loss on the WLAN encryption
settings within the device and that the default WEP key is active again
('Standard WEP encryption'
Antennas – Screw on the both included diversity antennas at the back of
the LANCOM Router base station.
LAN – First connect the LANCOM Router base station to your LAN or to
an individual PC. For that purpose, plug the included network cable (green
plugs) into the LAN connector of the device
free network connecting socket of your local network, into a free socket
of a hub/switch or into the network socket of an individual PC.
The LAN connector identifies automatically the transfer rate (10/100
Mbps) of the connected network device (autosensing). A parallel connec-
tion of devices with different speeds and types is possible.
You should never have more than one unconfigured LANCOM Router
in a network segment at any given time. All unconfigured LANCOM
Router devices use the same IP address (with the final digits '254'),
which would result in an address conflict. To avoid problems, always
configure multiple LANCOM Router devices one at a time, immedi-
ately assigning each device a unique IP address (one that does not
end with '254').
DSL – connect the WAN interface
supplied DSL connector cable (dark blue plugs).
ADSL – connect the ADSL interface
ADSL connector cable (transparent plugs).
ISDN – to connect the LANCOM Router to the ISDN, plug one end of the
supplied ISDN connector cable (light blue plugs) in the ISDN/S
the router and the other end into an ISDN/S
to-point mode connection.
USB port – you may optionally connect printers with USB connector to
the LANCOM and make them available to the entire network. The
Chapter 2: Installation
→
Page 67).
»
and the other end into a
¿
to the DSL modem socket using the
¿
to the splitter using the supplied
multi-device mode or point-
0
´
port
of
0
27
Advertisement
Table of Contents
